Area Attack Command

From Zero-K
Revision as of 00:43, 28 April 2020 by Stuff (talk | contribs) (results of testing)
Jump to navigation Jump to search

(WIP, Add more info)

Overview

Area attack is a permanent command (i.e. does not end unless cancel by the stop command or issuing another command) exclusive to bombers. It causes the bombers to attack any targets in the area or the ground if no targets can be spotted. The shots are distributed evenly overly all targets in the area or the area itself,

Issuing

The Default hotkey for Area Attack is Alt+A, it cannot be modified by the Ctrl Or Alt modifier. It cannot be issued to non-bomber units. Note that if issued to a bomber that has landed on the ground, it will not take effect until the bomber has taken off.

Usage

Area Attack can help put pressure on areas undefended by Anti-Air without demanding large amount of attention. It's use after Anti-Air becomes prevalent is highly advised against as the planes will be split into a steady stream rather than a large burst, making then far more vulnerable.