Editing Area Attack Command
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| + | (WIP, Add more info) | ||
== Overview == | == Overview == | ||
| − | Area | + | Area attack is a permanent command (i.e. does not end unless cancel by the stop command or issuing another command) exclusive to bombers. It causes the bombers to attack any targets in the area or the ground if no targets can be spotted. The shots are distributed evenly overly all targets in the area or the area itself, |
| − | |||
== Issuing == | == Issuing == | ||
| − | The Default hotkey for Area Attack is | + | The Default hotkey for Area Attack is Alt+A, it cannot be modified by the Ctrl Or Alt modifier. It cannot be issued to non-bomber units. Note that if issued to a bomber that has landed on the ground, it will not take effect until the bomber has taken off. |
| − | |||
== Usage == | == Usage == | ||
| − | Area Attack can help put pressure on areas undefended by Anti-Air without demanding large amount of attention. | + | Area Attack can help put pressure on areas undefended by Anti-Air without demanding large amount of attention. It's use after Anti-Air becomes prevalent is highly advised against as the planes will be split into a steady stream rather than a large burst, making then far more vulnerable. |
